Page 1 of 1

PostPosted: Mon Mar 22, 2004 10:27 am
by Eli
Hi, I have a small project that requires the use of the IRDA port. I need to send a series of commands in Hex (ie. 7F followed by 77 delay FF and AF) followed by receiving an acknowledge of one byte long.

I read the Pocket C instructions but the chat.c example does not seem to work. I found another post that mentions that the PToolbox incluedes the IRDA commands but i couldn't find it anywhere.

Those someone have an example of how to complete this commnad set and where i can find more information on the subject.

Much appreciated.



PostPosted: Mon Mar 22, 2004 12:10 pm
by jstadolnik
The library used to include a IR enable function, but it only worked on a few pre-OS4.0 devices, so I removed it when PocketC officially supported IR access with the seropenx() function.


The PToolboxLib guy.

PostPosted: Mon Mar 22, 2004 1:01 pm
by Eli
Thanks Joe, I guess I need to keep looking. Any Ideas of where i can find some more information on the subject? Should be simple enough but i was not able to get the demo to work.