Page 1 of 1

PostPosted: Thu Mar 17, 2005 10:30 pm
by kilivor
Hi again!

Can 'normal fonts' be used in the font escape codes? If yes, which are these codes? The doc says <i>The font escape code consist of four characters "`fXX", where XX is the hex value of the new font</i>. But I am not quite sure about this XX.

I tried with the codes described in the built-in textattr function (<i>Available fonts are normal[0], bold[1], large[2], symbol[3], symbol11[4], symbol7[5], LED[6], Large Bold[7] (OS 3.0 only)</i>

But it didn't worked. I just want to set the bold attribute in a few list members.

Thank you very much.

PostPosted: Fri Mar 18, 2005 12:51 am
by jstadolnik
Provided that you done a Fctl LISTHAND on the list, using "`f01Hello" should show up in bold.

Joe

The PToolboxLib guy.
http://www.geocities.com/retro_01775/PToolboxLib.htm

PostPosted: Fri Mar 18, 2005 12:11 pm
by kilivor
I was using "Hello`f01" :|

Thanks!