Page 1 of 1

PostPosted: Wed Apr 07, 2004 6:09 pm
by Jules Saunderson
Every now and again when I write large programs using Ccontrols some of the variables stop showing up, like I have them defined and have a Cdraw command for them but they refuse to show up on the screen. It's not a problem with that particular variable either cos if i change the order I define them in different ones don't show. This is pretty wierd and starting to really piss me off, any ideas?

I could send a section of the code if any1 could hav a look through it.?

PostPosted: Tue Apr 20, 2004 11:30 am
by Eli
Jules, i had a similar problem and i found that i was accidentally setting (manually not on the GUI) the x,y coordinates over each other. Maybe you could post your control settings to review.

Eli
http://eswhut.com