Page 1 of 1

PostPosted: Sun Sep 08, 2002 3:49 pm
by Guillaume
I would like to know if it exists a solution to adjust the system volkume settings in a PocketC program.
Thanks for your support

PostPosted: Sat Oct 05, 2002 6:11 am
by wolfgang
I was working on the same issue a long time ago. I found the registry entry that determines the volume. I can change it, but the change has no effect until you warm-reset you device, which cannot be done from within PocketC. I did not find a way to get the changes from PocketC through to WindowsCE.

That certainly did not help you :-)


Composing music on the PocketPC! -

PostPosted: Tue Oct 08, 2002 12:14 pm
by guy
I responded to this question in the main CE section of the forum a while ago. You just call the set volume function. Unfortunately this is useless if you are using PocketC V2.

PocketC CE API interface:
PCForm and CE API forum: