Page 1 of 1

PostPosted: Thu Mar 24, 2005 1:14 am
by otakribut1
refer http://www.microhobbykits.com
i'm using kit from the abovementioned url. i would like to know is it possible to use pocketC to program and run this board. such program could be for controlling servo motor, stepper motor, and get data from light sensor and etcs.
Refer to this for using Palm to control LEGO HC11 board.
http://www.harbaum.org/till/palm/pbrick
Refer acroname PPRK. palm control
http://www.acroname.com
to control LEGO using palm--use omniremote SDK from this link
http://www.pacificneotek.com/downloadAdvanced.htm